O&O Software DiskImage 9 Professional Uživatelská příručka stáhnout pdf (Strana 56)

Start directly from bootable disk

O&O DiskImage-47

Note: If you want to restore on different hardware, you should also consider the notes in chapter Machine inde-

pendent restoration (M.I.R.).

Note: The Start CD, needed for running O&O DiskImage without an operating system and for restoring system par-

titions, is not included n the O&O DiskImage Special Edition.

Loading drivers

If a device such as a hard disk or network card is not automatically recognized when using the bootable medium under

Windows PE, a necessary controller driver (e.g., RAID controllers) might be missing.

You can start loading a new driver immediately after inserting the Start CD using the dialog O&O System settings and

the tab Drivers.

Please follow these instructions for loading a new driver:

1. Open the tab Drivers in the dialog O&O System settings as described above. All recognized Windows devices

as well as all devices missing installed drivers will be displayed.

2. Select the device for which you want to load a driver.

3. Click Load.

4. Select the desired driver such as one on a connected hard disk, USB Stick or CD*.

5. In the dialog, select Open to install the driver.

6. You'll then see a program message informing you about the status of the installation.

* Note: You can remove the Start CD from the drive in order to insert a driver CD from a manufacturer.

Note: Under certain circumstances, you may receive a notice requiring you to restart if you have loaded an addi-

tional driver under Windows PE. This message is automatically generated by Windows PE but is irrelevant when

starting from a CD. Simply reject the request and follow the further instructions in the pop-up window.

Note: Encrypted drives are not supported under Windows PE

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 107 108

Žádné komentáře

O&O Software DiskImage 9 Professional Uživatelská příručka Strana 56